+(420) 315 707 111  My account

WM868-TI2

59,90 witout TAX

WM868-TI2 modules are designed for measuring the air temperature in interiors (residential buildings, warehouses, production halls s) with a recommended temperature range (0 ÷ 70) ° C.

499 in stock

Product Description

WM868-TI2 modules are designed for measuring the air temperature in interiors (residential buildings, warehouses, production halls…) with a recommended temperature range (0 ÷ 70) ° C. The modules are equipped with an integrated thermometer sensor, mounted directly on the printed circuit board. The module transmits the current temperature data via radio messages, either on request (via the “Wake-On Radio” system) or automatically at a set time interval. The instantaneous temperature message contains, in addition to the temperature data read by the thermometer, the system time of the module, the battery voltage and the processor temperature.

The transmitted messages are further transmitted via the WACO network to communication gateways of the type WM868-RFU (WACO USB Gateway), WM868-RFE (WACO Ethernet Gateway), or WM868-RFG (WACO GSM Gateway), where they are converted from radio format to communication format via serial line (WM868-RFU), suitable for processing by a local computer, or for communication format over a computer network (WM868-RFE / RFG), suitable for processing by a remote computer.

Alternatively, messages with consumption data can be transmitted to the so-called “collection unit” of the WACO system, which collects data from WM868-SI / SA / SISA and WM868-TI / TE modules in the WACO radio network, converting the collected data into standard M bus protocol messages -BUS and their further transmission in M-BUS format via the physical bus or in the virtual WACO bus.

The module with a transmitting power of 10 mW is powered by an internal battery with a capacity of 2.2 Ah.

The modules are equipped with a “Wake-On-Radio” system, which allows communication to be initiated on demand (outside the set interval). With a special radio message (“WOR-packet”), the modules can be immediately switched to the active state and current temperature information can be requested. This mode can be used to obtain instantaneous temperature and / or humidity information using a walk-through reading method (WALK-BY system), or to perform remote diagnostics and configuration of modules via a radio network.

Manual k WM868-TI2

Additional information

Weight 0.1 kg
Interface

Napájení

battery 2,2 Ah

Prostředí

IP20

výkon

10 mW

Reviews

There are no reviews yet.

Be the first to review “WM868-TI2”

Your email address will not be published. Required fields are marked *

You may also like…