€67,76 with TAX
WM868-TID.A (pencil batteries) are designed for measuring the air temperature in interiors (residential buildings, warehouses, production halls…) with a recommended temperature range (0 ÷ 70) ° C.
Out of stock
WM868-TID.A modules are designed for measuring the air temperature in interiors (residential buildings, warehouses, production halls…) with a recommended temperature range (0 ÷ 70) ° C. The modules are equipped with an integrated thermometer sensor, mounted directly on the printed circuit board.
The current temperature value is displayed on the LCD display, the module can also be used to set the “reference temperature” value using the control buttons (see chapter 5). The module automatically transmits both temperatures (current and reference) in an adjustable time interval in a message of the “INFO” type, which in addition to the data of both temperatures also contains the system time of the module and the battery voltage.
The transmitted messages are further transmitted via the WACO network to communication gateways of the WM868-RFU (WACO USB Gateway), WM868-RFE (WACO Ethernet Gateway) or WM868-RFG (WACO GSM Gateway), where they are converted from radio format to communication format via serial line (WM868-RFU), suitable for processing by a local computer, or for communication format over a computer network (WM868-RFE / RFG), suitable for processing by a remote computer.
Alternatively, messages with consumption data can be transmitted to the so-called “collection unit” of the WACO system, which collects data from the WM868-SI / SA / SISA and WM868-TI / TE modules in the WACO radio network, converting the collected data into standard M bus protocol messages -BUS and their further transmission in M-BUS format via the physical bus or in the virtual WACO bus.
The module with a transmitting power of 10 mW is powered by two replaceable AAA pencil batteries.
The modules are equipped with a “Wake-On-Radio” system, which allows communication to be initiated on demand (outside the set interval). With a special radio message (“WOR-packet”), the modules can be immediately switched to the active state and current temperature information can be requested. This mode can be used to obtain instantaneous temperature and / or humidity information using a walk-through reading method (WALK-BY system), or to perform remote diagnostics and configuration of modules via a radio network.
2 pcs AAA battery